These steps detail what needs to be done to get RS232 and Displayport loop-though working across all the screens connected.
Follow the Single Screen setup for each screen prior to this.
Cabling
To get Display port to work across all the screens, there is a special requirement to get all of them working together.
The screens require to be looped through from LCD 1's port 1 to LCD 2's port 2 etc.
To do this you:
Loop the 'out' into the 'in' of the next screen in order.
To set up the RS232 you need to:
Loop the 'out' from the first screen, into the 'in' of the second screen etc.
It should be looped as follows:
When this is done make sure to set the IP address to AUTO on the screen via the menu
And then set AUTO ID to YES
